Netgear ADSL Firewall Router DG834 User Manual Page 120

  • Download
  • Add to my manuals
  • Print
  • Page
    / 236
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 119
Reference Manual for the ADSL Firewall Router DG834
7-30 Virtual Private Networking (Advanced Feature)
202-10005-05, June 2005
Once the connection is established, you can open the browser of the PC and enter the LAN IP
address of the remote DG834. After a short wait, you should see the login screen of the Router
(unless another PC already has the DG834 management interface open).
Gateway-to-Gateway Configuration—test the VPN tunnel by pinging the remote network
from a PC attached to the DG834.
a. Open command prompt (i.e., Start -> Run -> cmd).
b. ping 192.168.3.1.
Figure 7-34: Pinging test results
Note: The pings may fail the first time. If so, then try the pings a second time.
Start Using a VPN Tunnel to Active It
To use a VPN tunnel, use a Web browser to go to a URL whose IP address or range is covered by
the policy for that VPN tunnel.
Verifying the Status of a VPN Tunnel
To use the VPN Status page to determine the status of a VPN tunnel, perform the following steps:
1. Log in to the Router.
2. Open the DG834 management interface and click on VPN Status to get the VPN Status/Log
screen (Figure 7-35).
Log—this log shows the details of recent VPN activity, including the building of the VPN
tunnel. If there is a problem with the VPN tunnel, refer to the log for information about what
might be the cause of the problem.
Click Refresh to see the most recent entries.
Click Clear Log to delete all log entries.
Page view 119
1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 235 236

Comments to this Manuals

No comments