Netgear WNHDE111 User Manual Page 70

  • Download
  • Add to my manuals
  • Print
  • Page
    / 82
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 69
WNHDE111 5GHz Wireless-N HD Access Point/Bridge User Manual
8-2 Troubleshooting
v1.1, May 2008
Make sure that the Ethernet cables are securely plugged in.
The Internet status light on the wireless range extender is on if the Ethernet cable connecting
the wireless range extender and the network is plugged in securely and the WNHDE111 is
turned on.
Be sure the LED on/off button on the back panel is set to on so that you can monitor the status
lights.
Make sure that the wireless settings in the computer and WNHDE111 match
exactly.
For a wirelessly connected computer, the wireless network name (SSID) and WEP or WPA
security settings of the WNHDE111 and wireless computer must match exactly.
If you have enabled the wireless range extender to restrict wireless access by MAC address,
you must add the wireless computers MAC address to the routers wireless card access list.
Make sure that the network settings of the computer are correct.
Wired and wirelessly connected computers must have network (IP) addresses on the same network
as the WNHDE111. The simplest way to do this is to configure each computer to obtain an IP
address automatically using DHCP. Click the link to the online document “Preparing Your
Network” in Appendix B, or see the documentation that came with your computer.
Troubleshooting Basic Functions
After you turn on power to the unit, the following sequence of events should occur:
1. When power is first applied, verify that the LED push button is set to on, and the Power light
is on.
2. After approximately 10 seconds, verify that:
a. The Power light is solidly on.
b. The status lights of any in-use Ethernet LAN port are on. This indicates that a link has
been established to the connected device.
If any of the above conditions does not occur, see the appropriate following section.
The Power light is not on or is blinking.
If the Power and other lights are off when your unit is turned on:
Page view 69
1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 81 82

Comments to this Manuals

No comments