Netgear WC7520 User Manual Page 31

  • Download
  • Add to my manuals
  • Print
  • Page
    / 213
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 30
System Planning and Deployment Scenarios
31
ProSafe 20-AP Wireless Controller WC7520
Single Controller Configuration with Advanced Profile Groups
A more complex configuration consists of a single wireless controller that controls a collection
of access points that are organized in access point profile groups and might use several
profiles in each access point profile group.
To set up a single wireless controller system with advanced profile groups:
Step Configuration Web management interface path
1. Optional: Create an RF plan. Plans > Layout
2. If you have not yet done so, configure the system settings of the
wireless controller:
1. Configure the country code of operation.
Configuration > System > General
2. Configure the IP address of wireless controller.
Configuration > System > IP/VLAN
3. Verify that VLAN 1 is set as the management VLAN and is
marked as untagged, which is the default setting.
3. Configure up to 8 access point profile groups, and for each
access point profile in a group, do at least the following:
1. Configure an SSID for wireless access.
Configuration > Profile > Advanced
2. Configure the network authentication and data encryption.
3. Assign the VLAN.
4. If required, configure the authentication server.
Configuration > Security >
Advanced > Authentication Server
5. Run the Discovery Wizard and add the access points to the
managed access point list.
Access Point > Discovery Wizard
6. Assign the access points to the access point profile groups (also
referred to as WLAN groups).
Configuration > WLAN Network
Page view 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 212 213

Comments to this Manuals

No comments