Managing Stacking and Redundancy
166
ProSafe 20-AP Wireless Controller WC7520
To modify the redundant controller after you have configured redundancy:
1. Click Replace. The Replacing Controller Information pop-up window displays.
Note: The Replace button displays onscreen only after a redundancy
con
figuration has become active. The button is shown on Figure 91 on
page 163.
2. Modif
y the settings as explained in Table 37 on page 164.
3. Click Apply. The modifie
d local IP address of the redundant controller is displayed above
the Redundancy table.
To delete a redundancy group:
Clear the Enabl
e Redundancy check box. Doing so causes the redundant controllers in the
redundancy group to reboot and return to the factory default state except for their IP address.
Comments to this Manuals