Netgear WG602v3 User's Guide download pdf (Page 60)

NETGEAR 54 Mbps Wireless Access Point WG602v3 Reference Manual

4-12 Advanced Configuration

v1.0, August 2006

• b only – Supports only 802.11b.

The default is g and b.

7. Click Apply to save your settings.

Verify your connection by clicking Site Survey. The ID radio button of your wireless

connection should be enabled. You can also click Information. The Associated AP should

show the MAC address of the remote AP. If no connection has been made, a “no association”

message will display.

The scenario below illustrates WG602v3 in Client Mode where multiple devices are connected

behind the wired Ethernet side (PC1 and Printer). The WG602v3 Client, with a Network Type of

Infrastructure, acts like a wireless bridge between two wired LANs. The WG602v3, in AP mode

on the other LAN, provides access to the Internet.

Table 4-1. Site Survey Fields

Field Description

ID Identifies a network that you can connect to or that you are connected to.

SSID The Service Set Identifier (SSID) of the access point or peer device. Note that, as a security

measure, some wireless access points do not broadcast their SSID. In such cases, the SSID

field will be blank even though the rest of the information will still be displayed.

Security Identifies the wireless network security type. In order to connect to this network you must

have the same security type enabled.

Mode Identifies the type of wireless network—Access Point (Infrastructure) or peer-to-peer (Ad

Hoc)

Channel Identifies the direct-sequence channel that the access point or peer is currently using.

Signal Identifies the signal strength of the communications.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 75 76

No comments

Netgear WG602v3 User's Guide Page 60