Netgear WG602v3 User's Guide Page 51

  • Download
  • Add to my manuals
  • Print
  • Page
    / 76
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 50
NETGEAR 54 Mbps Wireless Access Point WG602v3 Reference Manual
Advanced Configuration 4-3
v1.0, August 2006
5. Click Apply to save your changes.
The Remote Access Point MAC address will display in the Wireless Remote Access Point
List.
The following figure shows a point-to-point bridge between two wireless access points on two
LAN segments.
.
To set up this type of point-to-point configuration:
1. Configure AP1 in Point-to-Point mode with the MAC address of AP2 and deploy it on LAN
Segment 1. If you check the Enable Wireless Client Association checkbox, wireless clients
will also be able to use AP1. If the Enable Wireless Client Association checkbox is not
selected, only computers on Ethernet LAN segment 1 will be able to use AP1 to communicate
with AP2.
2. Configure AP2 in Point-to-Point mode with the MAC address of AP1 and deploy it on LAN
Segment 2. Use the same security and channel settings as AP1. If you check the Enable
Wireless Client Association checkbox, wireless clients will also be able to use AP2. If the
Enable Wireless Client Association checkbox is not selected, only computers on Ethernet
LAN segment 2 will be able to use AP2 to communicate with AP1.
3. Verify connectivity across the network.
If you enabled wireless client association on both APs, a computer on either AP should be able
to connect to the Internet or share files and printers of any other PCs or servers connected to
the network.
Figure 4-2
AP1
AP2
LAN
Segment 1
LAN
Segment 2
Point-to-Point
Mode
Point-to-Point
Mode
Hub or Switch
Router
Internet
Wireless PC Card
in a Notebook Computer
Wireless PC Card
in a Notebook Computer
192.168.0.1
PCs
PCs
Page view 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 75 76

Comments to this Manuals

No comments