Netgear WG602v3 User's Guide download pdf (Page 25)

NETGEAR 54 Mbps Wireless Access Point WG602v3 Reference Manual

Installation and Configuration 2-5

v1.0, August 2006

When the wireless access point is connected to the Internet, you can click the KnowledgeBase

link or the Documentation link under the Web Support menu to view support information or

the documentation for the wireless access point.

5. From the Setup menu on the left panel, select IP Settings. The IP Settings screen will display.

The wireless access point is shipped preconfigured to act as a DHCP client. Verify the default

settings (suitable for most users):

• Access Point Name. This is the name of your wireless access point.You may modify the

default name with a unique name up to 15 characters long. The default name is

netgearxxxxxx, where xxxxxxx represents the last 6 digits of the WG602 MAC address.

• DHCP Client: Enabled so that your wireless access point will get its TCP/IP

configuration from the DHCP server on your network.

• Spanning Tree Protocol. By default Spanning Tree Protocol is enabled. This provides

network traffic optimization in configurations with multiple Wireless APs.

You may manually configure the IP settings for the WG602v3 by checking the Disable radio

box for DHCP Client. The default IP configuration will display:

• IP Address: 192.168.0.227

• IP Subnet Mask: 255.255.255.0

Note: Unless you click Logout, the wireless access point will log you out after 5

minutes of no activity.

Figure 2-4

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 75 76

No comments

Netgear WG602v3 User's Guide Page 25