Netgear WG602v3 User's Guide download pdf (Page 29)

NETGEAR 54 Mbps Wireless Access Point WG602v3 Reference Manual

Installation and Configuration 2-9

v1.0, August 2006

Logging Into the WG602v3

The NETGEAR WG602v3 54 Mbps Wireless Access Point can be configured remotely from

Microsoft Internet Explorer browser version 5.0 or above, or Netscape Navigator Web browser

version 4.78 or above, or Mozilla Firefox. You can log in to the WG602v3 in these two ways:

• Using the IP Address of the WG602v3 (if DHCP client is disabled) or with a reserved IP

address assigned by your router (if DHCP client is enabled). Either one of these methods is the

most reliable.

• Using the NetBIOS name of the WG602v3, which is not as reliable as using an IP Address.

IP Address Login

The default IP address of your wireless access point is 192.168.0.227. However, if you have

disabled DHCP client (fixed or static IP address), you can change the IP Address and IP Subnet

Mask of your wireless access point.

To connect to the WG602v3 using a fixed, static or reserved IP address:

1. Open a Web browser.

2. Enter the IP Address of WG602v3 into your browser (the default IP address is

http://192.168.0.227).

Note: If you are using the default IP subnet, the computer you are using to connect to the

WG602v3 should be configured with an IP address that starts with 192.168.0.x and

a Subnet Mask of 255.255.255.0; if you have changed the subnet of the wireless

access point, the computer your are using to connect must be within the same

subnet.

Figure 2-6

http://192.168.0.227

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 75 76

No comments

Netgear WG602v3 User's Guide Page 29