Netgear RANGEMAX WAG302 User Manual download pdf (Page 80)

Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302

5-12 Advanced Configuration

202-10078-01

• All APs must be on the same LAN. That is, all the APs LAN IP address must be in the

same network.

• If using DHCP, all WAG302 Access Points should be set to “Obtain an IP address

automatically (DHCP Client)” in the IP Address Source portion of the Basic IP Settings

menu.

• All WAG302 Access Points use the same SSID, Channel, authentication mode, if any, and

encryption in use.

• All Point-to-Point APs must have AP2’s MAC address in its Remote AP MAC address

field.

3. Verify connectivity across the LANs.

• A computer on any LAN segment should be able to connect to the Internet or share files

and printers with any other PCs or servers connected to any of the three LAN segments.

• Wireless stations will not be able to connect to the WAG302 Access Points in the

illustration above. If you require wireless stations to access any lan segment, you can

additional WAG302 Access Points configured in Wireless Access Point mode to any LAN

segment.

Note: You can extend this multi-point bridging by adding additional WAG302s configured in

Point-to-Point mode for each additional LAN segment. Furthermore, you can extend the range of

the wireless network with NETGEAR wireless antenna accessories.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 119 120

No comments

Netgear RANGEMAX WAG302 User Manual Page 80