Netgear RANGEMAX WAG302 User Manual Page 83

  • Download
  • Add to my manuals
  • Print
  • Page
    / 120
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 82
Troubleshooting 6-1
202-10078-01
Chapter 6
Troubleshooting
This chapter provides information about troubleshooting your WAG302 ProSafe Dual Band
Wireless Access Point. After each problem description, instructions are given to help you diagnose
and solve the problem. For the common problems listed, go to the section indicated.
Is the WAG302 on?
Have I connected the wireless access point correctly?
Go to “Installing the WAG302 Access Point” on page 3-5.
I cannot remember the wireless access point’s configuration password.
Go to “Changing the Administrator Password” on page 4-13.
If you have trouble setting up your WAG302, check the tips below.
No lights are lit on the access point.
It takes a few seconds for the power indicator to light up. Wait a minute and check the
power light status on the access point.
If the access point has no power.
Make sure the power cord is connected to the access point.
Make sure the power adapter is connected to a functioning power outlet. If it is in a power
strip, make sure the power strip is turned on. If it is plugged directly into the wall, verify that it
is not a switched outlet.
Make sure you are using the correct NETGEAR power adapter supplied with your access
point.
Note: For up-to-date WAG302 installation details and troubleshooting guidance visit
http://kbserver.netgear.com/products/WG302.asp.
Page view 82
1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 119 120

Comments to this Manuals

No comments