Netgear RANGEMAX WAG302 User Manual download pdf (Page 85)

Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302

Troubleshooting 6-3

202-10078-01

I cannot connect to the WAG302 to configure it.

Check these items:

• The WAG302 is properly installed, LAN connections are OK, and it is powered on. Check that

the LAN port LED is green to verify that the Ethernet connection is OK.

• The default configuration of the WAG302 is for a static IP address of 192.168.0.230 and a

Mask of 255.255.255.0 with DHCP disabled. Make sure your network configuration settings

are correct.

• If you are using the NetBIOS name of the WAG302 to connect, ensure that your computer and

the WAG302 are on the same network segment or that there is a WINS server on your

network.

• If your computer is set to “Obtain an IP Address automatically” (DHCP client), restart it.

• If your computer uses a Fixed (Static) IP address, ensure that it is using an IP Address in the

range of the WAG302. The WAG302 default IP Address is 192.168.0.230 and the default

Subnet Mask is 255.255.255.0. If you are not sure about these settings, follow the instructions

for “Installing the WAG302 Access Point” on page 3-5.

When I enter a URL or IP address I get a timeout error.

A number of things could be causing this. Try the following troubleshooting steps.

• Check whether other PCs work. If they do, ensure that your PCs TCP/IP settings are correct. If

using a Fixed (Static) IP Address, check the Subnet Mask, Default Gateway, DNS, and IP

Addresses.

• If the PCs are configured correctly, but still not working, ensure that the WAG302 is connected

and turned on. Connect to it and check its settings. If you cannot connect to it, check the LAN

and power connections.

• If the WAG302 is configured correctly, check your Internet connection (DSL/Cable modem

etc.) to make sure that it is working correctly.

•Try again.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 119 120

No comments

Netgear RANGEMAX WAG302 User Manual Page 85