Netgear 802.11g User Manual download pdf (Page 74)

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302

6-4 Troubleshooting

September 2004

• Check whether other PCs work. If they do, ensure that your PCs TCP/IP settings are correct. If

using a Fixed (Static) IP Address, check the Subnet Mask, Default Gateway, DNS, and IP

Addresses.

• If the PCs are configured correctly, but still not working, ensure that the WG302 is connected

and turned on. Connect to it and check its settings. If you cannot connect to it, check the LAN

and power connections.

• If the WG302 is configured correctly, check your Internet connection (DSL/Cable modem

etc.) to make sure that it is working correctly.

•Try again.

Using the Reset Button to Restore Factory Default Settings

The Reset button (see “WG302 rear panel” on page 2-7) has two functions:

• Reboot. When pressed and released quickly, the WG302 will reboot (restart).

• Reset to Factory Defaults. This button can also be used to clear ALL data and restore ALL

settings to the factory default values.

To clear all data and restore the factory default values:

1. Power off the WG302 and power it back on.

2. Use something with a small point, such as a pen, to press the Reset button in and hold it in for

at least 5 seconds.

3. Release the Reset button.

The factory default configuration has now been restored, and the WG302 is ready for use.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 107 108

No comments

Netgear 802.11g User Manual Page 74