Netgear 802.11g User Manual download pdf (Page 49)

Management 4-1

September 2004

Chapter 4

Management

This chapter describes how to use the management features of your NETGEAR ProSafe Wireless

Access Point 802.11g WG302 . These features can be found by clicking on the Maintenance

heading in the Main Menu of the browser interface.

Using the Secure Telnet Interface

The WG302 includes a secure Telnet command line interface (CLI). You can access the CLI from

a secure Telnet client over the Ethernet port or over the serial console port.

How to Use the CLI via the Console Port

1. Using the null-modem cable, connect a VT100/ANSI terminal or a workstation to the

port labeled Console.

If you attached a PC, Apple Macintosh, or UNIX workstation, start a secure

terminal-emulation program.

2. Configure the terminal-emulation program to use the following settings:

• Baud rate: 9,600 bps

• Data bits: 8

• Parity: none

• Stop bit: 1

• Flow control: none

These settings appear below the connector on the back panel.

Note: You must use a secure Telnet client such as Absolute Telnet. Also, when you

configure the client, use the SSH1, 3DES option. If you use the Telnet client to connect

over the Ethernet port, use the IP address of the WG302 as the host name.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 107 108

No comments

Netgear 802.11g User Manual Page 49