Netgear 802.11g User Manual Page 26

  • Download
  • Add to my manuals
  • Print
  • Page
    / 108
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 25
Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
3-3 Basic Installation and Configuration
September 2004
Default Factory Settings
When you first receive your WG302, the default factory settings will be set as shown below. You
can restore these defaults with the Factory Default Restore switch on the rear panel — see
“WG302 front panel” on page 2-6.
FEATURE FACTORY DEFAULT SETTINGS
User Name (case sensitive) admin
Password (case sensitive) password
Operating Mode Access Point
Access Point Name netgearxxxxxx where xxxxxx are the last six
digits of the wireless access point's MAC address
Built-in DHCP client
Built-in DHCP server
DHCP client disabled
DHCP server disabled
IP Configuration
(if DHCP server is unavailable)
IP Address: 192.168.0.228
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
Network Name (SSID) NETGEAR
Broadcast Network Name (SSID Enabled
802.11g Radio Frequency Channel 11
AutoCell RF Management
AutoCell Enhanced RF Security ‘stealth’ mode
Enabled
Disabled
WEP/WPA Disabled
Restricting connectivity based on MAC Access
Control List
Disabled
Spanning Tree Protocol Enabled
Time Zone GMT
Time Zone Adjust for Daylight Saving TIme Disabled
SNMP Enabled but Trap forwarding is disabled
Secure Telnet Enabled
Page view 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 107 108

Comments to this Manuals

No comments