Netgear 802.11g User Manual Page 16
- Page / 108
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
2-2 Introduction
September 2004
Key Features
The WG302 Access Point is easy-to-use and provides solid wireless and networking support.
Supported Standards and Conventions
The following standards and conventions are supported:
• Standards Compliant. The Wireless Access Point complies with the IEEE 802.11g for
Wireless LANs.
• WEP support. Support for WEP is included. 64-bit, 128-bit, and 152-bit keys are supported.
• DHCP Client Support. DHCP provides a dynamic IP address to PCs and other devices upon
request. The WG302 can act as a client and obtain information from your DHPC server.
• SNMP Support. Support for Simple Network Management Protocol (SNMP) Management
Information Base (MIB) management.
Key Features
The NETGEAR WG302 provides solid functionality, including these features:
• AutoCell RF Management. AutoCell provides advanced automated RF management that
improves performance and enhances security.
• Multiple Operating Modes
– Wireless Access Point. Operates as a standard 802.11g.
– Point-to-Point Bridge. In this mode, the WG302 only communicates with another
bridge-mode wireless station. You must enter the MAC address (physical address) of the
other bridge-mode wireless station in the field provided. WEP should be used to protect
this communication.
– Point-to-Multi-Point Bridge. Select this only if this WG302 is the “Master” for a group
of bridge-mode wireless stations. The other bridge-mode wireless stations must be set to
Point-to-Point Bridge mode, using this WG302's MAC address. They then send all traffic
to this “Master”, rather than communicate directly with each other. WEP should be used to
protect this traffic.
– Wireless Repeater. In this half-duplex mode, the WG302 only communicates with
another repeater-mode wireless station. You must enter the MAC address of both adjacent
repeater-mode wireless stations in the fields provided. WEP should be used to protect this
communication.
• Upgradeable Firmware. Firmware is stored in a flash memory and can be upgraded easily,
using only your Web browser, and can be upgraded remotely.
- Reference Manual for the 1
- NETGEAR ProSafe Wireless 1
- Access Point 802.11g WG302 1
- Technical Support 2
- Trademarks 2
- Statement of Conditions 2
- Radio Frequency Notice 3
- DECLARATION OF CONFORMITY 4
- Contents 7
- September 2004 10
- Chapter 1 11
- About This Manual 11
- How to Use this Manual 12
- How to Print this Manual 13
- 1-4 About This Manual 14
- Chapter 2 15
- Introduction 15
- Key Features 16
- Introduction 2-3 17
- 2-4 Introduction 18
- System Requirements 19
- What’s In the Box? 19
- Hardware Description 20
- Introduction 2-7 21
- 2-8 Introduction 22
- Figure 2-2: WG302 rear panel 22
- Introduction 2-9 23
- Chapter 3 24
- Cabling Requirements 25
- Default Factory Settings 26
- 6HFXULW\2SWLRQV 27
- 5DQJH8SWR)RRW5DGLXV 27
- ET UP THE WG302 ACCESS POINT 28
- Figure 3-2: Login window 29
- EPLOY THE WG302 ACCESS POINT 32
- 4VERIFY WIRELESS CONNECTIVITY 33
- How to Configure WEP 44
- How to Configure WPA 45
- How to Configure WPA-PSK 45
- Figure 3-11: IP Settings menu 47
- •Time Zone 48
- Chapter 4 49
- Management 49
- CLI Commands 50
- Management 4-3 51
- 4-4 Management 52
- Statistics 53
- 4-6 Management 54
- Table 4-1. Statistics Fields 54
- Management 4-7 55
- Configuration File Management 56
- Management 4-9 57
- Apply to save your change 59
- 4-12 Management 60
- Chapter 5 61
- Advanced Configuration 61
- AutoCell RF Management 62
- Advanced Configuration 5-3 63
- 5-4 Advanced Configuration 64
- Advanced Configuration 5-5 65
- 5-6 Advanced Configuration 66
- Hub or Switch 67
- 192.168.0.1 68
- Segment 1 69
- 5-10 Advanced Configuration 70
- Chapter 6 71
- Troubleshooting 71
- The LAN light is not lit 72
- Troubleshooting 6-3 73
- Appendix A 75
- Specifications 75
- A-2 Specifications 76
- Appendix B 77
- Wireless Networking Basics 77
- 802.11 Authentication 79
- Open System Authentication 79
- Shared Key Authentication 80
- Overview of WEP Parameters 81
- Key Size 82
- Wireless Channels 83
- WPA Wireless Security 84
- How Does WPA Compare to WEP? 85
- Wired Network with Optional 88
- 802.1x Port Based Network 88
- Access Control 88
- Wireless LAN 88
- Is WPA Perfect? 92
- Product Support for WPA 92
- Appendix C 95
- Command Line Reference 95
- 2 Glossary 100
- 4 Glossary 102
- 6 Glossary 104
- Wireless Network Name (SSID) 105
- Glossary 106
Related products and manuals for WLAN access points Netgear 802.11g
WLAN access points Netgear WG602v2 User's Guide
(122 pages)
(122 pages)
WLAN access points Netgear ME102 User Manual
(17 pages)
(17 pages)
WLAN access points Netgear WAG302v1 User Manual
(108 pages)
(108 pages)
(28 pages)© 2020, manymanuals.com. All rights reserved. | 2.143 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals