Netgear FVS338 User Manual Page 101

  • Download
  • Add to my manuals
  • Print
  • Page
    / 198
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 100
FVS338 ProSafe VPN Firewall 50 Reference Manual
Virtual Private Networking 5-7
v1.0, March 2008
Reconnect after failure count: Fresh negotiation starts when no acknowledgement is
received for the specified number of consecutive packets.
Local. IP address (either a single address, range of address or subnet address) on your local
LAN. Traffic must be from (or to) these addresses to be covered by this policy. (Subnet
address is the default IP address when using the VPN Wizard).
Remote. IP address or address range of the remote network. Traffic must be to (or from) these
addresses to be covered by this policy. (The VPN Wizard default requires the remote LAN IP
address and subnet mask for a gateway policy).
AH. Authentication Header. This specifies the authentication protocol for the VPN header
(VPN Wizard default is disabled).
ESP. Encapsulating Security Payload. This specifies the encryption protocol used for the VPN
data (VPN Wizard default is enabled).
VPN Tunnel Connection Status
Recent VPN tunnel activity is shown on the IPSec Connection Status screen (accessed by
selecting VPN from the main menu and Connection Status from the submenu).You can set a Poll
Interval (in seconds) to check the connection status of all active IKE Policies to obtain the latest
VPN tunnel activity. The Active IPSec (SA)s table also lists current data for each active IPSec SA
(Security Association):
Policy Name. The name of the VPN policy associated with this SA.
Endpoint. The IP address on the remote VPN Endpoint.
Tx (KBytes). The amount of data transmitted over this SA.
Tx (Packets). The number of packets transmitted over this SA.
State. The current state of the SA. Phase 1 is “Authentication phase” and Phase 2 is “Key
Exchange phase”.
Action. Allows you to terminate or build the SA (connection), if required.
Page view 100
1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 197 198

Comments to this Manuals

No comments