Netgear WNHD3004 User's Guide download pdf (Page 48)

3DHD Home Theater Adapter WNHD3004 User Manual

6-8 Using Network Management Tools

v1.0, November 2010

To save your settings, click Back Up. Your browser extracts the configuration file from the bridge

and prompts you for a location on your computer to store the file. You can give the file a

meaningful name at this time, such as comcast.cfg.

To restore your settings from a saved configuration file, enter the full path to the file on your

computer, or click Browse to browse to the file. When you have located it, click Restore to send

the file to the router. The router then reboots automatically.

Erasing the Configuration

Under some circumstances (for example, if you move the router to a different network or if you

have forgotten the password) you might want to erase the configuration and restore the factory

default settings. After an erase, the unit’s password is password.

To erase the configuration, click the Erase button in the Settings Backup screen.

To restore the factory default configuration settings when you do not know the login password or

IP address, you must use the Restore Factory Settings button on the rear panel of the router (see

“Restoring the Default Configuration and Password” on page 7-3).

Upgrading the Software

The software (also called firmware) of the home theater adapter is stored in flash memory, and can

be upgraded as NETGEAR releases new software. Your unit can download and install the new

software.

Tip: Before saving your configuration file, change the administrator password to the

default, password. Then change it again after you have saved the configuration file.

If you forget the password, you will need to reset the configuration to factory

defaults.

Warning: Do not interrupt the reboot process.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 63 64

No comments

Netgear WNHD3004 User's Guide Page 48