Netgear WNHD3004 User's Guide download pdf (Page 11)

3DHD Home Theater Adapter WNHD3004 User Manual

Getting Started 1-3

v1.0, November 2010

Back Panel Connectors, Buttons, and Switches

• Auto. Auto is the factory default setting. In Auto mode, if the unit

senses it is connected to a router or gateway, it automatically sets

itself to run as an AP. Otherwise, if connected to any other wired

device, the unit automatically sets itself to run in Bridge mode.

• AP.

When switched to AP (access point) mode, the unit acts as an

access point. In this mode, connect it to a router. The free Ethernet

port can be used to connect other equipment to your network using

an Ethernet cable.

• Bridge. In

Bridge mode, connect devices to the unit using Ethernet

cables and they will connect to your wireless network. Typically,

when a unit is set to bridge mode, it is paired with a WNHD3004

working in AP mode.

This illustration identifies the connectors and switches on the back of the unit.

Figure 1-2

Table 1-1. Connectors and Buttons

Connector or Button Description

Power connector Port for connecting the AC power adapter.

Four Mbps Ethernet ports For connecting the unit using Ethernet cables to other equipment like

switches, game consoles, media adapters, print servers, or a router.

Factory default reset button Use a paper clip to press this button for about 10 seconds to reset the

unit to its factory default settings.

Mode switch settings

On/Off button Press this button to turn the WNHD3004 on or off.

Power connector

Ethernet Ports

On/Off button

Factory Reset Settings

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 63 64

No comments

Netgear WNHD3004 User's Guide Page 11