Netgear SRX5308 User Manual Page 40

  • Download
  • Add to my manuals
  • Print
  • Page
    / 460
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 39
IPv4 and IPv6 Internet and WAN Settings
40
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Protocol binding addresses two issues:
Segregation of traffic between links that are not of the same speed.
High-volume traffic can be routed through the WAN port connected to a high-speed link,
and low-volume
traffic can be routed through the WAN port connected to the low-speed
link.
Continuity of
source IP address for secure connections.
Some services, particularly HTTPS, cease to resp
ond when a client’s source IP address
changes shortly after a session has been established.
Configure Load Balancing Mode
To configure load balancing mode:
1. Select Network Configurati
on > WAN Settings > WAN Mode. The WAN Mode screen
displays:
Figure 20.
2. In the Load Balancing Settings section of the screen, configure the following settings:
a. Select the
Load Balancing Mode radio button.
b. From the co
rresponding drop-down list on the right, select one of the following load
balancing methods:
W
eighted LB. With weighted load balancing, balance weights are calculated
based on WAN link speed and available WAN bandwidth. This is the default
setting and most efficient load balancing algorithm.
Round-robi
n. With round-robin load balancing, new traffic connections are sent
over a WAN link in a serial method irrespective of bandwidth or link speed. For
example, if the WAN1, WAN2, and WAN3 interfaces are active in round-robin load
balancing mode, an HTTP request could first be sent over the WAN1 interface,
then a new FTP session could start on the WAN2 interface, and then any new
Page view 39
1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 459 460

Comments to this Manuals

No comments