Netgear WG602 User Manual download pdf (Page 33)

User’s Guide for the WG602 v3 54 Mbps Wireless Access Point

Basic Installation and Configuration 3-10

202-10060-01, September 2004

Using the Basic IP Settings Options

The IP Settings page is under the Setup heading of the main menu. Use this page to configure

DHCP, static IP, and the access point NetBIOS name.

Figure 3-8: Basic IP Settings page

• Access Point Name (NetBIOS)

You can change the access point name after the initial configuration. Enter a new name for the

wireless access point and click Apply to save your changes.

• The IP Address Source

The wireless access point is shipped preconfigured to use a private IP address on the LAN

side, and to act as a DHCP client. If the wireless access point does not find a DHCP server on

the Ethernet LAN, it defaults to this IP configuration:

– DHCP Client - Enable

– IP Address — 192.168.0.227

– IP Subnet Mask — 255.255.255.0

– Gateway — 0.0.0.0

If your network has a requirement to use a different IP addressing scheme, you can make those

changes in this page.

• Spanning Tree Protocol

Spanning Tree Protocol in enabled by default for the wireless access point. This provides

network traffic optimization in settings with multiple WG602 v3 Access Points.

Remember to click Apply to save your changes.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 119 120

No comments

Netgear WG602 User Manual Page 33