Netgear WG602 User Manual download pdf (Page 52)

User’s Guide for the WG602 v3 54 Mbps Wireless Access Point

5-4 Advanced Configuration

202-10060-01, September 2004

How to Configure Wireless Multi-Point Bridging

Figure 5-3: Wireless Bridging

Configure the Operating Mode of the WG602 v3 Access Points.

– AP1 on LAN Segment 1 in Point-to-Point Bridge mode with the Remote MAC Address of

AP2.

– Because it is in the central location, configure AP2 on LAN Segment 2 in Wireless

Multi-Point Bridging mode. Add the MAC addresses of the adjacent Point-to-Point APs

which are configured to communicating with it.

– Configure the AP3 on LAN 3 in Point-to-Point Bridge mode with the Remote MAC

Address of AP2.

2. Verify the following parameters for all access points:

• Verify that the LAN network configuration the WG602 v3 Access Points are configured to

operate in the same LAN network address range as the LAN devices

• Only one AP is configured in Wireless Multi-Point Bridging mode, and all the others are

in Point-to-Point Bridge mode.

• All APs must be on the same LAN. That is, all the APs LAN IP address must be in the

same network.

AP2

ETHERNET

LAN

Segment 1

192.168.0.1

Router

Hub or Switch

LAN

Segment 3

LAN

Segment 2

Hub or Switch

AP3

ETHERNET

AP1

ETHERNET

Wireless PC Card

in a Notebook Computer

Point-to-Multipoint

Mode

Point-to-Point

Mode

Point-to-Point

Mode

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 119 120

Comments to this Manuals

No comments

Netgear WG602 User Manual Page 52

Comments to this Manuals

Related products and manuals for WLAN access points Netgear WG602