Netgear WG602 User Manual download pdf (Page 87)

User’s Guide for the WG602 v3 54 Mbps Wireless Access Point

Network, Routing, Firewall, and Cabling Basics C-9

202-10060-01, September 2004

The WG602 v3 Access Point also functions as a DHCP client when connecting to the ISP. The

firewall can automatically obtain an IP address, subnet mask, DNS server addresses, and a

gateway address if the ISP provides this information by DHCP.

Domain Name Server

Many of the resources on the Internet can be addressed by simple descriptive names such as

www.netgear.com. This addressing is very helpful at the application level, but the descriptive name

must be translated to an IP address in order for a user to actually contact the resource. Just as a

telephone directory maps names to phone numbers, or as an ARP table maps IP addresses to MAC

addresses, a domain name system (DNS) server maps descriptive names of network resources to

IP addresses.

When a PC accesses a resource by its descriptive name, it first contacts a DNS server to obtain the

IP address of the resource. The PC sends the desired message using the IP address. Many large

organizations, such as ISPs, maintain their own DNS servers and allow their customers to use the

servers to look up addresses.

Routing Protocols

Two protocols routers use extensively are:

• Routing Information Protocol (RIP)

• Address Resolution Protocol (ARP)

These two protocols are introduced below.

RIP

One of the protocols used by a router to build and maintain a picture of the network is RIP. Using

RIP, routers periodically update one another and check for changes to add to the routing table.

The WG602 v3 Access Point supports both the older RIP-1 and the newer RIP-2 protocols.

Among other improvements, RIP-2 supports subnet and multicast protocols. RIP is not required

for most home applications.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 119 120

No comments

Netgear WG602 User Manual Page 87