Netgear WG602 User Manual download pdf (Page 30)

User’s Guide for the WG602 v3 54 Mbps Wireless Access Point

3-7 Basic Installation and Configuration

202-10060-01, September 2004

How to Log in Using the Default IP Address of the WG602 v3

1. 192.168.0.227 is the default IP address of your access point. However, the WG602 v3 is also

set, by default, to be a DHCP client. So, if the WG602 v3 has not yet been installed, and there

is no DHCP server on the network, you can log in to the WG602 v3 using its default IP

address. Otherwise, you should use either the NetBIOS login described in “How to Log In to

the WG602 v3 Using Its Default NetBIOS Name” on page 3-9 or the procedure described in

“Set up the WG602 v3 Access Point” on page 3-4” which uses a static IP configuration.

Note: The computer you are using to connect to the WG602 v3 should be configured with an

IP address that starts with 192.168.0.x and a Subnet Mask of 255.255.255.0.

2. Open a Web browser such as Internet Explorer or Netscape Navigator.

3. Connect to the WG602 v3 by entering its default address of http://192.168.0.227 into your

browser.

4. A login window like the one shown below opens:

Figure 3-4: Login window

Once you have entered your access point name, your Web browser should automatically find

the WG602 v3 Access Point and display the home page, as shown in “Login result: WG602 v3

home page” on page 3-8.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 119 120

No comments

Netgear WG602 User Manual Page 30