Netgear WG102 User Manual Page 25

  • Download
  • Add to my manuals
  • Print
  • Page
    / 118
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 24
Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102
Basic Installation and Configuration 3-3
202-10064-02, June 2005
Default Factory Settings
When you first receive your WG102, the default factory settings will be set as shown below. You
can restore these defaults with the Factory Default Restore switch on the rear panel — see
“WG102 front panel” on page 2-6.
FEATURE FACTORY DEFAULT SETTINGS
User Name (case sensitive) admin
Password (case sensitive) password
Operating Mode Access Point
Access Point Name netgearxxxxxx where xxxxxx are the last six digits of
the wireless access point's MAC address
Built-in DHCP client DHCP client disabled, it uses the default IP address
IP Configuration IP Address: 192.168.0.229
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
Network Name (SSID)
NETGEAR
Broadcast Network Name (SSID) Enabled
802.11g Radio Frequency Channel Auto
WEP/WPA Disabled
AutoCell RF Management
AutoCell Enhanced RF Security
Enabled
Disabled
Restricting connectivity based on MAC Access
Control List
Disabled
Time Zone GMT
Time Zone Adjust for Daylight Saving TIme Disabled
SNMP Disabled
Page view 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 117 118

Comments to this Manuals

No comments