Netgear WG102 User Manual download pdf (Page 76)

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102

5-10 Advanced Configuration

202-10064-02, June 2005

How to Configure Multi-Point Wireless Bridging

Figure 5-6: Multi-Point bridging

Configure the Operating Mode of the WG102 Access Points.

• Because it is in the central location, configure WG102 (AP1) on LAN Segment 1 in

Point-to-Multi-Point Bridge mode. The MAC addresses of AP2 and AP3 are required in

AP1.

• Configure WG102 (AP2) on LAN Segment 2 in Point-to-Point Bridge mode with the

Remote MAC Address of AP1.

• Configure the WG102 (AP3) on LAN 3 in Point-to-Point Bridge mode with the Remote

MAC Address of AP1.

2. Verify the following parameters for all access points:

• Verify that the LAN network configuration of the WG102 Access Points are configured to

operate in the same LAN network address range as the LAN devices

• Only one AP is configured in Point-to-Multi-Point Bridge mode, and all the others are in

Point-to-Point Bridge mode.

• All APs must be on the same LAN. That is, all the APs LAN IP address must be in the

same network.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 117 118

No comments

Netgear WG102 User Manual Page 76