ProSafe Dual Band Wireless Access Point WAG302 Reference Manual (802.11a/g)
Management 3-11
v2.0, May 2006
The Web browser used to upload new firmware into the WAG302 must support HTTP uploads,
such as Microsoft Internet Explorer 6.0 or above, or Netscape Navigator 4.78 or above.
To upgrade the WAG302 firmware:
1. Download the new software file from the NETGEAR website, save it to your hard disk, and
unzip it.
2. From the main menu under Management, select Upgrade Firmware. The Upgrade Firmware
screen will display as shown in Figure 3-7.
3. In the Upgrade Firmware menu, click Browse and browse to the location of the image (.RMG)
upgrade file.
4. Click Upload.
When the upload completes, your wireless access point will automatically restart. The upgrade
process typically takes about 1 minute.
In some cases, you may need to reconfigure the wireless access point after upgrading.
Configuration File Management
The WAG302 Wireless Access Point settings are stored in the wireless access point in a
configuration file. This file can be saved (backed up) to a user’s computer, retrieved (restored)
from the user’s computer, or cleared to factory default settings.
Warning: When uploading software to the WAG302 Wireless Access Point, it is
important not to interrupt the Web browser by closing the window, clicking a
link, or loading a new page. If the browser is interrupted, the upload may fail,
corrupt the software, and render the WAG302 completely inoperable.
Figure 3-7
Comments to this Manuals