Netgear WAB102 User's Guide download pdf (Page 18)

User’s Guide for the WAB102 802.11a+b Dual Band Wireless Access Point

Setting Up Basic Wireless Connectivity

For advanced users: To access the built-in Web Server home page on the

WAB102, we suggest that you have a DHCP server on the Ethernet Network.

If there is no accessible DHCP server, the WAB102 Access Point will default

to the IP address of 192.168.0.226 with a subnet mask of 255.255.255.0. You

will need to configure the IP address of the computer to be within the same

subnet for the initial configuration.

Having problems? Refer to Chapter 4, “Troubleshooting”.

4. Click AP Setup to configure the WAB102 Access Point, and proceed to

the next section, Log In to the Access Point.

To set up your access point, complete the following login steps:

1. Click on the AP Setup link on the WAB102 Web Server home page.

2. The Enter Network Password window will be displayed, as shown above.

Enter the default user name

admin with the default password 1234 in this

window.

Note: Both the user name and password are case sensitive.

You may change the password at any time after this point by choosing

Password from the AP Setup menu

3. Click OK. The TCP/IP LAN Setup window will be displayed as shown below.

Configure Basic Setup Parameters

To set up your access point, complete the following:

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 48 49

No comments

Netgear WAB102 User's Guide Page 18