Netgear WAB102 User's Guide download pdf (Page 15)

User’s Guide for the WAB102 802.11a+b Dual Band Wireless Access Point

12 Setting Up Basic Wireless Connectivity

5. Verify the installation was successful.

The Power light should be lit. It might take a few seconds after the power is

applied to the access point for the power light to appear. The Ethernet Link

light should be on. If the connection is a 100 Mbps connection, the light is

green. If it is a 10 Mbps connection, the light is amber. The Ethernet

connection light also flashes to indicate data is moving over the Ethernet

connection to the switch, router, or hub. The 802.11a or 802.11b Wireless

Link light should be on and blinking. A slow blink indicates that the access

point is looking for wireless nodes, or that very little wireless activity is taking

place. A fast blink indicates that the access point is receiving or transmitting

wireless data.

6. Verify wireless connectivity to your network.

Using a computer with an 802.11a or 802.11b wireless adapter, browse

internet or check file access on your network. If everything is functioning

properly, then you have successfully installed the WAB102 Dual Band

Wireless Access Point.

Having problems? Refer to Chapter 4, “Troubleshooting”.

Want to customize configuration settings? For details on WAB102 settings,

turn to

“Basic Configuration“ on page 14.

Note: Once the system is working, consider increased security. See

Chapter 3, “Protecting Your Wireless Network”.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 48 49

No comments

Netgear WAB102 User's Guide Page 15