Netgear WAB102 User's Guide download pdf (Page 13)

User’s Guide for the WAB102 802.11a+b Dual Band Wireless Access Point

10 Setting Up Basic Wireless Connectivity

Cabling Requirements

The WAB102 dual band AP connects to your LAN via twisted-pair Category 5

Ethernet cable with RJ-45 connectors.

Installation Overview

Please follow these instructions to successfully install your WAB102.

1. Install the WAB102 Access Point. See below.

2. Configure the Access Point. Turn to page 14.

Install the WAB102 Wireless Access Point

Before installing the WAB102 802.11 a+b Dual Band Wireless Access Point, you

should make sure that your Ethernet network is up and working. You'll be

connecting the access point to the Ethernet network so that computers with either

802.11a or 802.11b wireless adapters will be able to communicate with computers

on the Ethernet network. In order for this to work correctly, please verify that you

have met all of the system requirements, shown on

page 3.

Please follow the steps below to successfully install the WAB102 802.11 a+b Dual

Band Wireless Access Point.

Note: The power adapter and cord shipped with the WAB102 limits the

distance from an AC outlet. To overcome this, consider using

NETGEAR’s POE101 Power Over Ethernet Adapter with a Category 5

Ethernet cable like the one included with your WAB102. This adapter

sends DC power through an Ethernet cable to enable you to power an

access point in a remote location.

Note: See “System Requirements“ on page 3 for the minimal system

requirements for installing the WAB102.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 48 49

No comments

Netgear WAB102 User's Guide Page 13