Netgear R6200 User Manual Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 130
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
Hardware Setup
10
Dual Band 11ac WiFi Router R6200
Front and Side Panel
The router front panel has the status LEDs and icons shown in the following figure.
LEDs
WiFi On/Off button
WPS button
Figure 2. Router front and side view
Table 1. Front panel LED descriptions
LED Description
Power
Solid amber. The router is starting up.
Blinking amber.
The firmware is upgrading, or the Restore Factory Settings button was
pressed.
Solid green. The
router is ready.
Blinking green. The
firmware is corrupted. See www.netgear.com/support.
Off. Power is not supplied to the router
.
Internet
Solid green. The Internet connection is ready.
Solid amber.
The Ethernet cable connection to the modem has been detected.
Off. No Ethernet cable is connected to the modem.
Wireless
Solid blue. The wireless radio is operating in either 2.4 GHz or 5 GHz mode.
Blinking:
The router is in WPS mode.
Off.
The wireless radios are off for both 2.4 GHz and 5 GHz.
USB Solid blue: The router has accepted the USB device. The USB device is ready to be used.
Blinking blue:
A USB HDD is plugged in and is trying to connect.
Off: No USB device is connected, someone clicked the Safely Remove Hardware button and
it is now safe to remove the attached USB device.
The WiFi and WPS buttons toggle the WiFi and WPS functions on and off.
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 129 130

Comments to this Manuals

No comments