Netgear ADSL2+ Modem Router DM111PSPv2 User Manual download pdf (Page 63)

ADSL2+ Modem Router DM111PSPv2 User Manual

Advanced WAN Configuration 5-5

v1.0, December 2008

5. Click Next to continue. The WAN IP Settings screen displays.

6. Enter or select the WAN IP settings that are explained in the following table. Your ISP will

advise you which settings to use.

Figure 5-4

Table 5-4. WAN IP Settings

Setting Description

IP address Select a radio button for the IP address setting:

• Obtain an IP address automatically. The modem router acquires the IP

address automatically.

• Use the following IP address. Enter an IP address in the WAN IP Address

field.

Enable NAT Select this check box to enable NAT, which automatically assigns private IP

addresses (10.1.1.x) to LAN-connected devices.

PPP IP extension Select this check box to enable the modem router to function in semi bridge mode.

This option is available only when the IP address is obtained automatically and

when NAT is disabled.

Add Default Route Select this check box to set the current PVC as the default route. If this check box

is deselected, the first PVC that was enabled is set as the default route.

MTU The normal MTU (Maximum Transmit Unit) value for most Ethernet networks is

1500 bytes, or 1492 bytes for PPPoE connections. For some ISPs you might need

to reduce the MTU. This is rarely required, and should not be done unless you are

sure it is necessary for your ISP connection.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 87 88

No comments

Netgear ADSL2+ Modem Router DM111PSPv2 User Manual Page 63