Netgear 54 Mbps Wireless Game Adapter WGE111 User Manual download pdf

)NSTALLATION'UIDE

Wireless Game Adapter WGE111

Start Here

Unpack the box, verify the contents, and follow the instructions below. You can also

consult the Reference Manual on the NETGEAR, Inc. Web site at

http://kbserver.netgear.com/products/wge111.asp

The WGE111 Wireless Game Adapter operates in either Infrastructure or Ad-Hoc mode.

If you would like to change the default IP address or access the wireless game adapter

Web configuration console, see the “Smart Wizard Configuration Assistant” section on

this card. The default IP address is 192.168.0.202.

Mode Switch Position Your System

Infrastructure mode

(labeled Internet)

Left position, which is the

factory shipped default

Access point or wireless router connected

to a wired network

Ad-Hoc mode Right position (must be

changed from default left

position)

Small, wireless-only network and all

devices have wireless transmitters/

receivers.

7'%7IRELESS'AME!DAPTER

)NTERNET

!D(OC

Internet Game Console Plug-and-Go

What you need

• Broadband Internet access through a router with an 802.11b or 802.11g wireless

access point (built in to the router or separate) without any security features enabled.

Note: If you enabled security features (like WEP, WPA-PSK, SSID broadcast off,

MAC filtering, etc.) you need to follow the instructions in the Reference Manual.

• A network-enabled game console.

What you do

1. Connect the Ethernet cable from your WGE111 Wireless Game Adapter (A) to the

Ethernet port (B) in the game console.

2. Make sure that the switch on the back of the WGE111 is set to the left side (labeled

Internet), which corresponds to Infrastructure Mode.

3. Connect the power adapter to the WGE111 and verify the following:

• The power light goes on.

• The Internet light is lit.

• The Ethernet light is lit when connected to a powered on network-

enabled game console.

4. Enjoy your Internet gaming!

WGE111 Wireless

Game Adapter

Gaming Console or other

Ethernet-enabled device

Personal Computer Plug-and-Go

What you need

• Broadband Internet access through a router with an 802.11b or 802.11g wireless

access point (built in to the router or separate) without any security features enabled.

• A computer to run the initial configuration.

What you do

1. Connect the Ethernet cable from your WGE111 Wireless Game Adapter (A) to the

Ethernet port on your computer (B).

2. Make sure that the switch on the back of the WGE111 is set to the left side (labeled

Internet), which corresponds to Infrastructure Mode.

3. Connect the power adapter to the WGE111 and verify the following:

• The power light goes on.

• The Internet light is lit.

• The Ethernet light is lit.

4. Enjoy your Internet gaming!

WGE111 Wireless Game Adapter

1 2

Summary of Contents

Page 1 - Start Here

)NSTALLATION'UIDEWireless Game Adapter WGE111Start HereUnpack the box, verify the contents, and follow the instructions below. You can also cons

Page 2 - Technical Support

2005.03.14Smart Wizard Configuration AssistantYou can use the NETGEAR Smart Wizard configuration assistant to change the IP settings of the adapter. C

Comments to this Manuals

No comments

Netgear 54 Mbps Wireless Game Adapter WGE111 User Manual

Browse online or download User Manual for Hardware Netgear 54 Mbps Wireless Game Adapter WGE111. NETGEAR 54 Mbps Wireless Game Adapter WGE111 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Netgear 54 Mbps Wireless Game Adapter WGE111