Netgear R6300 User Manual download pdf (Page 36)

NETGEAR genie ADVANCED Home

R6300v2 Smart WiFi Router

 To change the LAN settings:

1. Select ADVANCED > Setup > LAN Setup.

2. Enter the settings that you want to customize.

These settings are described in the following section, LAN Setup Screen Settings.

3. Click the Apply button.

Your changes are saved.

LAN Setup Screen Settings

LAN TCP/IP Setup

• IP Address. The LAN IP address of the router.

• IP Subnet Mask.

The LAN subnet mask of the router. Combined with the IP address, the

IP subnet mask allows a device to know which other addresses are local to it, and which

have to be reached through a gateway or router.

• RIP Direction. Router Information Protocol (RIP) allows a router to exchange routing

information with other routers.

This setting controls how the router sends and receives

RIP packets. Both is the default setting. With the Both or Out Only setting, the router

broadcasts its routing table periodically. With the Both or In Only setting, the router

incorporates the RIP information that it receives.

• RIP V

ersion. This setting controls the format and the broadcasting method of the RIP

packets that the router sends. It recognizes both formats when receiving. By default, the

RIP function is disabled.

- RIP-1 is universally supported. It is adequate for most networks, unless you have an

unusual network setup.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 132 133

No comments

Netgear R6300 User Manual Page 36