Netgear MBR1210 User's Guide download pdf (Page 9)

Chapter 1. Connecting to the Internet | 9

Mobile Broadband 11n Wireless Router MBR1210 User Manual

Power Solid green The router is turned on and operating normally.

Solid amber POST (power-on self-test) in progress.

Off Power is not supplied to the router.

Internet Port

Solid green There is an Internet session.

Solid amber Traffic meter limit has been reached, traffic is blocked.

Blinking green Data is being transmitted over the Internet connection.

Blinking amber Traffic meter limit has been reached, but traffic not blocked.

Blinking green and amber Failover from WAN to Mobile Broadband.

Off No Internet connection detected.

Wi-Fi

Solid blue The Wi-Fi local port is initialized.

Blinking blue Data is being transmitted or received over the Wi-Fi link.

Off The wireless access point is turned off.

LAN Ports

Solid green The local Ethernet ports have detected wired links with PCs.

Blinking Data is being transmitted or received.

Off No link is detected on these ports.

WAN Port

Solid green The Ethernet WAN port has detected an active link.

Blinking Data is being transmitted or received.

Off No link is detected on these ports.

2G/3G

Solid blue Indicates the router is in 3G+ coverage.

Solid green Indicates the router is in 2G coverage.

Off No coverage is detected.

Signal Quality

Solid blue Excellent coverage detected.

Solid green Good coverage detected.

Solid amber Marginal coverage detected.

Off No coverage detected.

Restore Factory

Settings

Locate the small hole outlined in red on the back of the router. Insert a paperclip into the hole

and push for 6 seconds. Depressing the reset button causes the LED to blink briefly. After the

button is held down for more than 6 seconds, the LED will flash AMBER, and then turn green

as the router resets to the factory defaults. See

Table 1. LED Descriptions

LED Activity Description

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 200 201

No comments

Netgear MBR1210 User's Guide Page 9