Netgear WNDR3400 User Manual download pdf (Page 20)

N600 Wireless Dual Band Router WNDR3400 Setup Manual

Installing Your Wireless Router Manually (Advanced and Linux Users) 17

• Internet. The Internet port light (5) should be lit. If it is not, make sure that the Ethernet cable

is securely attached to the wireless router Internet port and that the modem, and that the

modem is powered on.

• LAN. A LAN light (6) should be lit. Green indicates that your computer is communicating at

100 Mbps; amber indicates 10 Mbps. If a LAN light is not lit, check that the Ethernet cable

from the computer to the router is securely attached at both ends, and that the computer is

turned on.

Setting Up Your Router for Internet Access

When configuring your wireless router manually, you must log in to your wireless router to set it

up initially and to make any changes to your wireless router’s settings later.

To access your router:

1. Connect to the wireless router by typing http://www.routerlogin.net in the address field of

your browser, and then press Enter.

The factory default state is reset when you use the Restore Factory Settings button.

See “Restoring the Default Password and Configuration Settings” on page 42 for

more information.

Figure 10

Connect to the wireless router by typing any one of these three URLs in the address

field of your browser, then pressing Enter:

• http://www.routerlogin.net

•

http://www.routerlogin.com

• http://192.168.1.1

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

No comments

Netgear WNDR3400 User Manual Page 20