Netgear WGT624v4 User Manual download pdf (Page 9)

Router Setup Manual

Connecting the Router to the Internet 1-5

v1.0, April 2007

Manual Setup

There are two steps to setting up your router:

1. Connect the router to the ADSL or cable modem, and connect a computer to the router.

2. Configure the router to use your Internet service.

Connecting Your Router

1. Connect the router, the computer, and the modem.

a. Turn off your computer.

b. Turn off and unplug the cable or ADSL broadband modem.

c. Locate the Ethernet cable (1) that connects your computer to the modem.

d. Disconnect the cable at the modem end only (2).

Note: Your computer has to be set to automatically get its TCP/IP network settings

from the router via DHCP. This is usually the case. If your are unsure about

this, use the wizard on the CD which automatically takes care of this for you,

or refer to the documentation for your computer.

Figure 1-3

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

No comments

Netgear WGT624v4 User Manual Page 9