Netgear WG511v2 User Manual download pdf (Page 19)

User Manual for the NETGEAR 54 Mbps Wireless PC Card WG511v2

Basic Setup 3-3

v2.2, December 2005

Your NETGEAR 54 Mbps Wireless PC Card WG511v2 factory default basic settings are:

• Network Name Service Set Identification (SSID): Any (First available network)

• Network Mode (Infrastructure or Ad-hoc): Infrastructure

• Data security WEP or WPA-PSK encryption: Disabled

The section below provides instructions for setting up the NETGEAR 54 Mbps Wireless PC Card

WG511v2 for basic wireless connectivity to an access point. The procedures below provide step-

by-step installation instructions for Windows PCs. Use the procedure that corresponds to the

version of Windows that you are using.

Basic Installation Instructions

Use the procedure below that corresponds to the version of Windows you are using.

For Windows XP Users Installing a WG511v2

1. First, install the WG511v2 software.

Note: In order for the WG511v2 Wireless PC Card to communicate with a wireless

access point or wireless adapter, all devices must be set up to use the same

wireless network name (SSID).

a. Insert the NETGEAR CD.

If the CD

main page does not appear, double click

autorun.exe on the CD.

b. Click the Install Software link and the

Smart Wizard starts.

c. Follow the Wizard steps, and click Next

to continue.

d. When the Installation Complete

message appears, click Next.

Figure 3-1

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 55 56

No comments

Netgear WG511v2 User Manual Page 19