Netgear Modem FVS318N User Manual Page 98

  • Download
  • Add to my manuals
  • Print
  • Page
    / 425
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 97
LAN Configuration
98
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
To delete one or more advertisement prefixes:
1. On the RADVD screen for the DMZ screen (see Figure 47 on page 95), select the check
box to the left of each advertisement prefix that you want to delete, or click the Select
All t
able button to select all advertisement prefixes.
2. Click the Delete t
able button.
Manage Static IPv4 Routing
Configure Static IPv4 Routes
Configure the Routing Information Protocol
IPv4 Static Route Example
Static routes provide additional routing information to your wireless VPN firewall. Under
normal circumstances, the wireless VPN firewall has adequate routing information after it has
been configured for Internet access, and you do not need to configure additional static routes.
You should configure static routes only for unusual cases such as multiple firewalls or
multiple IP subnets located on your network.
Note: The wireless VPN firewall automatically sets up routes between
VLANs and secondary IPv4 addresses that you have configured on
the LAN Multi-homing (IPv4) screen (see
Configure IPv4 Multihome
LAN IP Addresses on the Default VLAN on p
age 65). Therefore, you
do not need to manually add an IPv4 static route between a VLAN
and a secondary IPv4 address.
Configure Static IPv4 Routes
To add an IPv4 static route to the Static Route table:
1. Select Netwo
rk Configuration > Routing. In the upper right of the screen, the IPv4
radio button is selected by default. The Static Routing screen displays the IPv4 settings.
(The following figure contains one example.)
Figure 49.
Page view 97
1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 424 425

Comments to this Manuals

No comments