Netgear DGB111G Operations Instructions Page 135

  • Download
  • Add to my manuals
  • Print
  • Page
    / 268
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 134
Reference Manual for the Model Wireless ADSL Firewall Router DG834G
Virtual Private Networking (Advanced Feature) 8-29
202-10006-05, June 2005
To activate the VPN tunnel by pinging the remote endpoint (e.g., 192.168.3.1), do the following
steps depending on whether your configuration is client-to-gateway or gateway-to-gateway:
Client-to-Gateway Configuration—to check the VPN Connection, you can initiate a request
from the remote PC to the DG834G’s network by using the “Connect” option in the
NETGEAR ProSafe menu bar. The NETGEAR ProSafe client will report the results of the
attempt to connect. Since the remote PC has a dynamically assigned WAN IP address, it must
initiate the request.
To perform a ping test using our example, start from the remote PC:
a. Establish an Internet connection from the PC.
b. On the Windows taskbar, click the Start button, and then click Run.
c. Type ping -t 192.168.3.1 and then click OK.
Figure 8-32: Running a Ping test to the LAN from the PC
This will cause a continuous ping to be sent to the first DG834G. After between several
seconds and two minutes, the ping response should change from “timed out” to “reply.”
Note: Use Cntl-C to stop the pinging.
Figure 8-33: Ping test results
Page view 134
1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 267 268

Comments to this Manuals

No comments