Netgear WNDAP380Rv2 User Manual download pdf (Page 144)

Command-Line Reference

144

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R

| | |-port --Syslog server port number

| | |-server --Syslog server IP address

| | |-status --Enable syslog client

| |

| |-time-settings> --Time Setting

| | |-ntp> --NTP sever settings

| | | |-client --Client enable

| | | |-custom-server --Custom server enable

| | | |-server --Server host name

| | |

| | |-timezone --Time zone

| |

| |-vlan> --VLAN settings

| | |-management-vlan --VLAN management-id

| | |-untagged-vlan id --Untagged VLAN-id

| |

|-untagged-vlan-status --Untagged vlan status

| |

|-exit --Logout from CLI

|-firmware-upgrade --Upload new system firmware file fromftp

| server

|-firmware-upgrade-tftp --Upload new system firmware file

| fromtftp server

|-reset-ap --Reset the ap

|-restore-configuration --Restore system configuration

|-restore-default-password --Restore default system password

|-restore-factory-default --Restore default system configurations

|-save-and-activate –-Save and activate configuration

|-show> --Show system settings

| |-country --Show Country

| |-dhcp --Show DHCP settings

| |-ethernet> --Ethernet interface

| | |-statistics --Show ethernet statistics

| |-hotspot--Show hotspot settings

| |-ip> --IP settings

| | |-config --Show IP

configurations

| | |-status --Show IP status

| |-log --Show system logs

| |-name --Show ap name

| |

| |-radio>

| | |-2.4 --Show 2.4GHz wlan interface settings

| | |-2.4> --2.4GHz wlan interface settings

| | | |-associated-client --Associated client(s)

| | | |-macacl --Wireless access control (ACL) mac

| | | | address list

| | | |-rogue-ap-detection> --Rogue ap detection

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 150 151 152

Comments to this Manuals

No comments

Netgear WNDAP380Rv2 User Manual Page 144

Comments to this Manuals

Related products and manuals for WLAN access points Netgear WNDAP380Rv2