Netgear WG302v1 User Manual Page 31

  • Download
  • Add to my manuals
  • Print
  • Page
    / 98
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 30
NETGEAR ProSafe 802.11g Wireless Access Point WG302 Reference Manual
Basic Installation and Configuration 2-7
v4.0, April 2006
7. Configure the wireless interface for wireless access. See the online help or “Configuring
Wireless Settings” on page 2-11 of this Reference Manual for full instructions.
Now that you have finished the setup steps, you are ready to deploy the WG302 in your
network. If needed, you can now reconfigure the computer you used in step 1 back to its
original TCP/IP settings.
Step 3: Deploy the ProSafe 802.11g
1. Disconnect the WG302 and position it where you will deploy it. The best location is elevated,
such as wall mounted or on the top of a cubicle, at the center of your wireless coverage area,
and within line of sight of all the mobile devices.
2. Lift the antenna on either side so that they are vertical.
3. Connect an Ethernet cable from your ProSafe 802.11g to a LAN port on your router, switch, or
hub.
Figure 2-4.
Note: You must set the Regulatory Domain. It may not be legal to operate the
wireless access point in a region other than one of those identified in this field.
Note: Consult the antenna positioning and wireless mode configuration information
in “Advanced Configuration” on page 4-1 of the Reference Manual.
United States
Rest of World
Page view 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 97 98

Comments to this Manuals

No comments