Netgear WAG311 Installation Guide download pdf (Page 15)

Installation Guide for the NETGEAR Dual Band Wireless PCI Adapter WAG311

Introduction 1-5

Connect to the

Internet over my

wireless

network.

1. Activate my

wireless link

and verify my

network

connection.

2. Open an

Internet

browser such

as Internet

Explorer or

Netscape

Navigator.

1. An active Internet connection

like those from cable or DSL

service providers.

2. A wireless network connected

to the cable or DSL Internet

service through a cable/DSL

router as illustrated in

“Connect to an Access Point in

Infrastructure Mode” on

page 3-3.

3. TCP/IP Internet networking

software installed and

configured on my PC

according to the requirements

of the Internet service provider

4. A browser like Internet

Explorer or Netscape

Navigator.

To configure your WAG311 in

Infrastructure Mode, see “Basic

Setup” on page 2-1, and locate

the section for your version of

Windows.

For assistance with configuring

the TCP/IP Internet software on

a PC, see “Preparing Your

Computers for TCP/IP

Networking” on page C-1 or refer

to the PC Networking Tutorial on

the NETGEAR Dual Band

Wireless PCI Adapter WAG311

Resource CD (SW-10015-01)

and the Help information

provided in the Windows system

you are using.

Table 1-1. A Road Map for How to Get There From Here

If I Want To ... ? What Do I Do? What’s Needed? How Do I?

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 78 79

Comments to this Manuals

No comments

Netgear WAG311 Installation Guide Page 15

Comments to this Manuals

Related products and manuals for WLAN access points Netgear WAG311