Netgear PROSAFE WG302 User Manual download pdf (Page 9)

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302

Basic Installation and Configuration 3-9

July 2005 v3.0

Click the Wireless Settings link in the Setup section of the main menu to view the Wireless

Settings menu.

Figure 3-5: Basic Wireless Settings menu

Configure the wireless interface for wireless access. See the online help or the

Understanding Basic Wireless Settings topic of this Reference Manual for full

instructions.

Note: You must set the Regulatory Domain. It may not be legal to operate the wireless

access point in a region other than one of those identified in this field.

Now that you have finished the setup steps, you are ready to deploy the WG302 in your

network. If needed, you can now reconfigure the computer you used in step 1 back to its

original TCP/IP settings.

3DEPLOY THE WG302 ACCESS POINT

a. Disconnect the WG302 and position it where you will deploy it. The best location is

elevated, such as wall mounted or on the top of a cubicle, at the center of your wireless

coverage area, and within line of sight of all the mobile devices.

b. Lift the antenna on either side so that they are vertical.

Note: Consult the antenna positioning and wireless mode configuration information in the

Advanced Configuration chapter of the Reference Manual.

c. Connect an Ethernet cable from your WG302 Access Point to a LAN port on your router,

switch, or hub.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

No comments

Netgear PROSAFE WG302 User Manual Page 9