Netgear PROSAFE WG302 User Manual download pdf (Page 3)

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302

Basic Installation and Configuration 3-3

July 2005 v3.0

Default Factory Settings

When you first receive your WG302, the default factory settings will be set as shown below. You

can restore these defaults with the Factory Default Restore switch on the rear panel — see

“WG302 front panel” on page 2-6.

FEATURE FACTORY DEFAULT SETTINGS

User Name (case sensitive) admin

Password (case sensitive) password

Operating Mode Access Point

Access Point Name netgearxxxxxx where xxxxxx are the last six

digits of the wireless access point's MAC address

Built-in DHCP client

Built-in DHCP server

DHCP client disabled

DHCP server disabled

IP Configuration

(if DHCP server is unavailable)

IP Address: 192.168.0.228

Subnet Mask: 255.255.255.0

Gateway: 0.0.0.0

Network Name (SSID) NETGEAR

Broadcast Network Name (SSID) Enabled

802.11g Radio Frequency Channel 11

AutoCell RF Management

AutoCell Enhanced RF Security ‘stealth’ mode

Enabled

Disabled

WEP/WPA Disabled

Restricting connectivity based on MAC Access

Control List

Disabled

Spanning Tree Protocol Enabled

Time Zone GMT

Time Zone Adjust for Daylight Saving TIme Disabled

SNMP Enabled but Trap forwarding is disabled

Secure Telnet Enabled

SugerG Mode Disabled

WMM Mode Disabled

1 2 3 4 5 6 7 8 ... 33 34

No comments

Netgear PROSAFE WG302 User Manual Page 3