Netgear AirCard 595 (Sprint) User's Guide download pdf (Page 23)

Section 2A: Installing the Software 15

2. Use the Next and Back buttons to navigate through the wizard, noting the

following:

䡲 You must select I accept the terms in the license agreement to indicate your

acceptance of the terms of the license agreement to proceed with the

installation.

䡲 Use the default settings for the Destination Folder unless you have special

requirements and an advanced understanding of PC configuration. (The

Destination Folder dictates where the software is installed.)

3. At the end of the installation, you will be prompted to restart your computer.

Ensure that you save your work in other applications, if applicable.

4. When the “Installation Complete!” window is displayed, click Restart to restart

Windows.

5. When Windows has restarted, run Sprint PCS Connection Manager.

(Double-click the program’s icon [ ] on your desktop.)

6. Once Sprint PCS Connection Manager displays “No device,” insert the card into

the PC Card slot, Sprint label facing up. (See page 18.)

Windows detects the card and installs the drivers for it. This may take a few

minutes. Once completed, Sprint PCS Connection Manager should display

“Disconnected.”

Proceed to configure the Sprint Mobile Broadband Card to use your account (if it

was not preactivated); see “Activating and Using Sprint PCS Service” on page 22. If

your card is preactivated, then you are ready to connect to the network; to learn

about using the software, see “Your Sprint Mobile Broadband Card: The Basics” on

page 29.

Note:

If you have an older version of Sprint PCS Connection Manager and are

experiencing problems during installation, use the Add/Remove Programs

Utility (see page 49) to remove the older version of Sprint PCS Connection

Manager. Then reinstall the current version of Sprint PCS Connection

Manager from the Installation CD.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 128 129

No comments

Netgear AirCard 595 (Sprint) User's Guide Page 23