NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG111v3 User Manual
2-6
v1.0, March 2008
To connect the wireless adapter to an access point or router that supports WPS, do one of the
following:
• Connect during initial installation. See “Using the Smart Wizard to Set up Your Wireless
Adapter” on page 1-4.
• Click the Join a Network button on the Smart Wizard Settings screen. See Figure 1-5 on page
1-6. The wireless adapter detects all access points or routers in your neighborhood that support
WPS, and guides you through connecting, as described in this section.
• Click an access point or router that supports WPS in the Networks tab (see “Viewing Wireless
Networks in Your Area” on page 2-2).
There are two methods to connect using WPS:
• Push Button Configuration (PBC). To enable WPS, press a push button or push dome on the
access point or router, or click an onscreen button in the software. This is a fairly new
technology, so not all access points and routers provide a PBC.
• PIN entry. To enable WPS, use the NETGEAR Smart Wizard to generate a Personal
Identification number (PIN) that is associated with the access point or router.
Using a WPS Button to Connect to a Wireless Access Point or Router
To join a network using a PBC:
1. Use the icon to open the Smart Wizard. On the status bar, click Join a Network. The
adapter detects a network with WPS:
2. Select Yes to use WPS, and then click Next.
3. Select Yes (to use a push button), and then click Next.
Figure 2-4
Comments to this Manuals