Netgear DM602 User Manual download pdf (Page 55)

Reference Manual for the Model DM602 ADSL Modem

Troubleshooting 6-3

Troubleshooting the ISP Connection

ADSL link

If your modem is unable to access the Internet, you should first determine whether you have an

ADSL link with the service provider. The state of this connection is indicated with the WAN LED.

WAN LED Green or Blinking Green

If your WAN LED is green or blinking green, then you have a good ADSL connection. You can be

confident that the service provider has connected you line correctly and that your wiring is correct.

WAN LED Blinking Yellow

If your WAN LED is blinking yellow then your modem is attempting to make an ADSL

connection with the service provider. The LED should turn green within several minutes.

If the WAN LED does not turn green, disconnect all telephones on the line. If this solves the

problem, reconnect the telephones one at a time, being careful to use a microfilter on each

telephone. If the microfilters are connected correctly, you should be able to connect all your

telephones.

If disconnecting telephones does not result in a green WAN LED there may be a problem with

your wiring. If the telephone company has tested the ADSL signal at your Network Interface

Device (NID), then you may have poor quality wiring in your house.

WAN LED Off

If the WAN LED is off, disconnect all telephones on the line. If this solves the problem, reconnect

the telephones one at a time, being careful to use a microfilter on each telephone. If the microfilters

are connected correctly, you should be able to connect all your telephones.

If disconnecting telephones does not result in a green WAN LED the problem may be one of the

following:

• Check that the telephone company has made the connection to your line and tested it.

• Verify that you are connected to the correct telephone line. If you have more than one phone

line, be sure that you are connected to the line with the ADSL service. It may be necessary to

use a swapper if you ADSL signal is on pins 1 and 4 or the RJ-11 jack. The Model DM602

modem uses pins 2 and 3.

DM602.book Page 3 Monday, August 12, 2002 6:09 PM

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 65 66

No comments

Netgear DM602 User Manual Page 55