Netgear DM602 User Manual download pdf (Page 34)

Reference Manual for the Model DM602 ADSL Modem

3-10 Preparing Your Computer

If an ISP technician configured your computer during the installation of the service for a static IP

address, or if you configured it for a static IP address using instructions provided by your ISP, you

need to be sure you have that configuration information recorded. You will need to your

computer’s TCP/IP settings to use DHCP, then connect to the modem to configure it to operate in

Modem Device Mode. Once the modem is set to operate in Modem Device Mode, you will need to

reconfigure your computer with the static TCP/IP configuration you recorded from your ISP.

Restarting the Computer

Once you’ve set up your computer to work with the modem, you must reset the devices to be able

to communicate correctly.

1. Pull the modem’s power adapter out of the socket on the back, then put it back in to reset

it, and wait about 10 seconds.

2. Restart the computer that is connected to the modem.

Ready for Configuration

After configuring your computer for TCP/IP networking and connecting it to the Model DM602

modem, you are ready to access and configure the modem. Proceed to the next chapter.

DM602.book Page 10 Monday, August 12, 2002 6:09 PM

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 65 66

No comments

Netgear DM602 User Manual Page 34