Netgear WGE111 User Manual download pdf (Page 23)

User Manual for the NETGEAR WGE111 Wireless Game Adapter

Basic Setup 3-5

Note: Follow the instructions in your PS2 or Xbox manual to configure the IP, DNS, and other

parameters of your game console. If you want to change the default IP address or configure the

WGE111 Wireless Game Adapter from a Web browser, see “Planning the WGE111 Wireless

Game Adapter Configuration” on page 3-6 and “Using the NETGEAR Smart Wizard

Configuration Assistant” on page 3-9.

Personal Computer Plug-and-Go Scenario

Figure 3-3: Personal Computer Scenario

What you need.

• Broadband Internet access through a router with an 802.11b or 802.11g wireless access point

(built in to the router or separate) without any security features enabled.

• A computer to run the initial configuration.

What you do.

1. Connect the Ethernet cable from your WGE111 Wireless Game Adapter (A) to the Ethernet

port on your computer (B).

2. Make sure that the switch on the back of the WGE111 is set to the left side (labeled Internet),

which corresponds to Infrastructure Mode.

3. Connect the power adapter to the WGE111 and verify the following:

• The power light goes on.

• The Internet light is lit.

• The Ethernet light is lit.

WGE111 Wireless Game Adapter

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 87 88

No comments

Netgear WGE111 User Manual Page 23