Installing the ME101
This section provides instructions for connecting the ME101 802.11b Wireless Ethernet Bridge
to any Ethernet-enabled device using the default settings.
Note: If you find that the default settings don’t work, if you know that you’ve configured your
wireless network with WEP security, or if you are not in the United States, you’ll have to
configure the bridge before connecting it to the Ethernet-enabled device. To configure the
bridge, see Configuring Your ME101 on page 6.
1. Unpack the box and verify the contents.
2. Identify a flat surface where you will put the wireless bridge. For best results, follow
these guidelines:
• Place it away from potential sources of interference, such as computers, monitors,
TVs, microwaves, cordless phones, or large metal surfaces.
Warning: Failure to follow these guidelines can cause intermittent or complete failure
of wireless connectivity.
• Place it in an elevated location such as a high shelf or on a wall in the center of
your wireless access area.
3. Lift the bridge’s antenna so it is vertical.
4
2
2
Comments to this Manuals